Characteristic Angles in the Wetting of an Angular Region: Deposit Growth

TL;DR

This paper theoretically analyzes the evaporation, flow, and deposit growth patterns in a drying drop over an angular sector, revealing asymptotic laws and how deposit mass varies with distance and angle.

Contribution

It develops a hydrodynamic model near the vertex of an angular drop and derives asymptotic power laws for deposit growth and evaporation rates.

Findings

Deposit mass near the vertex follows a weak power law with distance.

Growth rate of deposits increases rapidly during early drying stages.

Power laws depend on the opening angle of the sector.

Abstract

As was shown in an earlier paper [1], solids dispersed in a drying drop migrate to the (pinned) contact line. This migration is caused by outward flows driven by the loss of the solvent due to evaporation and by geometrical constraint that the drop maintains an equilibrium surface shape with a fixed boundary. Here, in continuation of our earlier paper [2], we theoretically investigate the evaporation rate, the flow field and the rate of growth of the deposit patterns in a drop over an angular sector on a plane substrate. Asymptotic power laws near the vertex (as distance to the vertex goes to zero) are obtained. A hydrodynamic model of fluid flow near the singularity of the vertex is developed and the velocity field is obtained. The rate of the deposit growth near the contact line is found in two time regimes. The deposited mass falls off as a weak power Gamma of distance close to the vertex and as a stronger power Beta of distance further from the vertex. The power Gamma depends only slightly on the opening angle Alpha and stays between roughly -1/3 and 0. The power Beta varies from -1 to 0 as the opening angle increases from 0 to 180 degrees. At a given distance from the vertex, the deposited mass grows faster and faster with time, with the greatest increase in the growth rate occurring at the early stages of the drying process.