# Charge Transport and Thermoelectric Properties of Bornite with Fe-Site Off-Stoichiometry

## TL;DR

This study explores how varying iron content in bornite affects its crystal structure and thermoelectric performance, showing improved efficiency in Fe-deficient samples.

## Contribution

The paper introduces a systematic investigation of Fe non-stoichiometry's impact on bornite's thermoelectric properties and microstructure.

## Key findings

- Fe-deficient bornite samples showed enhanced power factors and lower thermal conductivity.
- Fe-excess samples exhibited n-type behavior and a sign reversal in Seebeck coefficients at high temperatures.
- The Cu5Fe0.94S4 composition achieved a ZT of 0.61 at 673 K, a 30–70% improvement over the stoichiometric composition.

## Abstract

The effects of Fe non-stoichiometry on crystal structure, microstructural evolution, and thermoelectric transport properties were systematically investigated in bornite (Cu5Fe1+yS4; −0.06 ≤ y ≤ 0.06) synthesized by mechanical alloying followed by hot pressing. X-ray diffraction analysis confirmed the formation of a single-phase orthorhombic bornite structure over the entire composition range. Anisotropic lattice distortion was observed with increasing Fe non-stoichiometry, manifested as contraction along the a-axis and expansion along the b- and c-axes, with a non-linear dependence on composition. Crystallite sizes estimated from Lorentzian peak fitting increased from 64.1 nm for the stoichiometric composition to 70.6–76.3 nm for Fe-deficient samples and 73.2–90.9 nm for Fe-excess samples. Hall-effect measurements revealed p-type semiconducting behavior for the stoichiometric composition, degenerate p-type transport with increased hole concentration under Fe-deficient conditions, and a transition to n-type behavior with reduced carrier mobility under Fe-excess conditions. While Fe-deficient samples retained high electrical conductivity and positive Seebeck coefficients, Fe-excess samples exhibited negative Seebeck coefficients at low temperatures with sign reversal at elevated temperatures. As a consequence, the power factor of Fe-deficient samples was enhanced by approximately 20–30% relative to the stoichiometric composition. In addition, the total thermal conductivity remained below 0.8 W·m−1·K−1 for all samples, and Fe non-stoichiometry effectively suppressed lattice thermal conductivity. Consequently, the Cu5Fe0.94S4 composition achieved a maximum dimensionless figure of merit of ZT = 0.61 at 673 K, representing a performance enhancement of approximately 30–70% compared with the stoichiometric composition (ZT = 0.36 at 673 K and 0.47 at 723 K).