# Design of a Low-Power RFID Sensor System Based on RF Energy Harvesting and Anti-Collision Algorithm

## TL;DR

This paper presents a low-power RFID sensor system that improves energy harvesting and reduces power consumption using a new anti-collision algorithm.

## Contribution

A co-optimized RFID system with enhanced energy harvesting and a novel anti-collision algorithm for improved efficiency.

## Key findings

- Improved RF energy harvesting circuit achieved 68.69% maximum conversion efficiency.
- Sensor load current dropped to 74 μA in idle state using power gating strategy.
- DTS-DFSA algorithm outperforms existing low-complexity schemes in efficiency and complexity.

## Abstract

Passive radio frequency identification (RFID) sensing systems integrate wireless energy transfer with information identification. However, conventional passive RFID systems still face three key challenges in practical applications: low RF energy harvesting efficiency, high power consumption of sensor loads, and high complexity of tag anti-collision algorithms. To address these issues, this paper proposes a hardware–software co-optimized RFID sensor system. For hardware, low threshold RF Schottky diodes are selected, and an input inductor is introduced into the voltage multiplier rectifier to boost the signal amplitude, thereby enhancing the radio frequency to direct current (RF-DC) energy conversion efficiency. In terms of loading, a low-power management strategy is implemented for the power supply and control logic of the sensor node to minimize the overall system energy consumption. For algorithmic implementation, a Dual-Threshold Stepped Dynamic Frame Slotted ALOHA (DTS-DFSA) anti-collision algorithm is proposed, which adaptively adjusts the frame length based on the observed collision ratio, eliminating the need for complex tag population estimation. The algorithm features low computational complexity and is well suited for resource constrained embedded platforms. Through simulation validation, we compare the conversion efficiency of the RF energy harvesting circuit before and after improvement, the current of the sensor load in active and idle states, and the performance of the proposed algorithm against the low-complexity DFSA (LC-DFSA). The results show that the maximum conversion efficiency of the improved RF energy harvesting circuit has increased from 60.56% to 68.69%; specifically, the sensor load current drastically drops from approximately 2.0 mA in the active state to around 74 μA in the idle state, validating the efficacy of the proposed power gating strategy, and the proposed DTS-DFSA algorithm outperforms existing low-complexity schemes in both identification efficiency and computational complexity.