# Model-Driven Processing of Passive Seismic While Drilling Data Acquired Using Distributed Acoustic Sensing Without Conventional Drill-Bit Pilot Measurements

## TL;DR

This paper introduces a new method to process seismic data collected while drilling using DAS, without needing traditional pilot measurements, enabling better subsurface imaging.

## Contribution

A novel model-driven workflow for processing passive seismic while-drilling data using DAS without conventional pilot measurements.

## Key findings

- Passive seismic data can be transformed into active equivalents using travel time and seismic modeling.
- Reliable subsurface velocity and structural information can be recovered without pilot signals.
- The workflow simplifies and scales passive seismic while-drilling data processing.

## Abstract

This article presents an advanced processing workflow for a Seismic While Drilling (SWD) dataset acquired using Distributed Acoustic Sensing (DAS) in a cross-well setting at the Otway International Test Centre (OITC) in Victoria, Australia, where no pilot signals were recorded. Recording the drill bit signature enables and simplifies the decoding of passive seismic signals emitted by the drill bit while drilling. In conventional SWD, a measured drill bit signature is used to correlate passive seismic recordings and to determine source trigger times, analogous to vibroseis processing. Without this reference, both source timing and signature must be inferred from the recorded wavefield. This can typically be achieved by backpropagating the recorded seismic data over short time windows, estimating the source location and trigger time based on the peak RMS energy in space and time. However, to simplify the processing of SWD data, a data processing workflow is presented, guided by travel time and seismic modelling, which transforms passive SWD data into active equivalents. The transformed data can then be used to characterize the subsurface by implementing travel time tomography and cross-well imaging. The results demonstrate reliable velocity and structural information can be recovered from DAS-based SWD data without pilot measurements, enabling simplified and scalable deployment of passive seismic while-drilling workflows.