# Fabrication of a Superhydrophobic Surface via Wet Etching of a Polydimethylsiloxane Micropillar Array

## TL;DR

This paper describes a method to create superhydrophobic surfaces using etched PDMS micropillars, achieving high water contact angles and low sliding angles.

## Contribution

A novel fabrication method for superhydrophobic PDMS surfaces using wet etching and analysis of their wettability properties.

## Key findings

- Etching time reduces micropillar diameters, increasing contact angles beyond 150° when W/D and H/D ratios exceed 1.5.
- Sliding angles decrease significantly at the threshold of superhydrophobicity.
- Acetone etching is 6–8 times faster than NMP, aligning with literature data.

## Abstract

Superhydrophobic surfaces have gained considerable attention due to their ability to repel water and reduce surface adhesion, and they are now widely applied for self-cleaning, anti-fouling, anti-icing, and corrosion resistance purposes. In this study, either a computer numerical control (CNC) machine or photolithographic techniques were employed to fabricate molds with microwells, followed by soft lithography to obtain a polydimethylsiloxane (PDMS) micropillar array. An etching process was then carried out. It was found that, as etching time increased, the diameters of micropillars decreased, leading to a decrease in the solid fraction of the composite surface and increases in contact angles. When the ratios of spacing to diameter (W/D) and of height to diameter (H/D) both exceeded 1.5, the contact angle was found to exceed 150° and the original PDMS micropillar surface with a contact angle of around 135° became superhydrophobic. A drastic decrease in sliding angle was also observed at this threshold. Changes in contact angles with different W/D values were in good agreement with values calculated using the Cassie–Baxter equation, and the droplet state was verified by a pressure balance model. Meanwhile, the PDMS etching rate when using acetone as the solvent was approximately 6–8 times faster than that when using 1-Methyl-2-pyrrolidone (NMP), a result which is comparable to data in the literature.