# Effect of Heat Treatment Duration on the Recrystallization and Electrochemical Properties of Cold-Rolled Cantor-Type High-Entropy Alloy

## TL;DR

This study shows how heat treatment duration affects the structure and corrosion resistance of a Cantor-type high-entropy alloy.

## Contribution

The study identifies the minimum heat treatment time needed to reduce residual stresses and restore corrosion resistance in cold-rolled Cantor alloy.

## Key findings

- Grain coarsening and stress reduction begin after 5 minutes of heat treatment at 1100°C.
- Corrosion resistance improves as the passive layer resistance increases from 39 to 56 kΩ.
- Optimal heat treatment enhances electrochemical properties and microstructure homogeneity.

## Abstract

High-entropy alloys (HEAs), such as the Cantor alloy, are considered for various structural applications owing to their excellent corrosion resistance and high strength at low temperatures, typically below −70 °C, including cryogenic conditions. However, during metalworking, introducing stresses and grain refinement can reduce the corrosion resistance of HEAs. Recrystallization heat treatment relieves these stresses and homogenizes the grain structure, thereby restoring their corrosion resistance and physical properties. However, inadequate heat treatment can result in a microstructure in which coarse and refined grains coexist; thus, the corrosion resistance is diminished and the physical properties are compromised. Therefore, a proper heat treatment is essential for achieving the desired corrosion resistance and mechanical properties of HEAs. In this study, a cold-rolled high-entropy Cantor alloy was subjected to heat treatment for various durations, and the conditions were analyzed. The microstructure and electrochemical behavior were examined. The results indicated that the grains coarsened after a heat treatment time of 5 min and the residual stresses decreased for 15 min. The potential increased from −0.20 to −0.09 V, whereas the resistance of the passive layer increased from 39 to 56 kΩ. These findings confirm that in the Cantor alloy, residual stress reduction and recrystallization begin after 5 min of heat treatment at 1100 °C, which contributes to the recovery of corrosion resistance. The corrosion resistance of the Cantor alloy can be effectively controlled through heat treatment. This underscores the importance of optimizing the heat treatment process in the manufacturing of Cantor alloys.