# Validation of dual-energy CT-based composition analysis using fresh animal tissues and composition-optimized tissue equivalent samples

**Authors:** Katharina Niepel, Sebastian Tattenberg, Raanan Marants, Guyue Hu, Thomas Bortfeld, Joost Verburg, Atchar Sudhyadhom, Guillaume Landry, Katia Parodi

PMC · DOI: 10.1088/1361-6560/ad68bc · 2024-08-12

## TL;DR

This study validates a dual-energy CT method for estimating tissue composition, which could improve proton therapy accuracy by reducing range uncertainties.

## Contribution

The study introduces a validated DECT-based method for estimating elemental composition in tissues, showing better accuracy than standard methods.

## Key findings

- DECT estimates of carbon and oxygen content in soft tissues had root-mean-square errors of 8.5 wt% and 9.5 wt% compared to chemical analysis.
- Phosphorus and calcium content predictions were accurate within 0.4 wt% and 1.1 wt% of chemical analysis results.
- The method performed best for tissues with compositions close to tabulated values and less inhomogeneous samples.

## Abstract

Objective. Proton therapy allows for highly conformal dose deposition, but is sensitive to range uncertainties. Several approaches currently under development measure composition-dependent secondary radiation to monitor the delivered proton range in-vivo. To fully utilize these methods, an estimate of the elemental composition of the patient’s tissue is often needed. Approach. A published dual-energy computed tomography (DECT)-based composition-extraction algorithm was validated against reference compositions obtained with two independent methods. For this purpose, a set of phantoms containing either fresh porcine tissue or tissue-mimicking samples with known, realistic compositions were imaged with a CT scanner at two different energies. Then, the prompt gamma-ray (PG) signal during proton irradiation was measured with a PG detector prototype. The PG workflow used pre-calculated Monte Carlo simulations to obtain an optimized estimate of the sample’s carbon and oxygen contents. The compositions were also assessed with chemical combustion analysis (CCA), and the stopping-power ratio (SPR) was measured with a multi-layer ionization chamber. The DECT images were used to calculate SPR-, density- and elemental composition maps, and to assign voxel-wise compositions from a selection of human tissues. For a more comprehensive set of reference compositions, the original selection was extended by 135 additional tissues, corresponding to spongiosa, high-density bones and low-density tissues. Results. The root-mean-square error for the soft tissue carbon and oxygen content was 8.5 wt% and 9.5 wt% relative to the CCA result and 2.1 wt% and 10.3 wt% relative to the PG result. The phosphorous and calcium content were predicted within 0.4 wt% and 1.1 wt% of the CCA results, respectively. The largest discrepancies were encountered in samples whose composition deviated the most from tabulated compositions or that were more inhomogeneous. Significance. Overall, DECT-based composition estimations of relevant elements were in equal or better agreement with the ground truth than the established SECT-approach and could contribute to in-vivo dose verification measurements.

## Full-text entities

- **Chemicals:** carbon (MESH:D002244), calcium (MESH:D002118), oxygen (MESH:D010100), phosphorous (-)
- **Species:** Homo sapiens (human, species) [taxon 9606]

## Figures

29 figures with captions in the complete paper: https://tomesphere.com/paper/PMC11334240/full.md

---
Source: https://tomesphere.com/paper/PMC11334240