# Optimal Planting Density Increases the Seed Yield by Improving Biomass Accumulation and Regulating the Canopy Structure in Rapeseed

## TL;DR

This study finds that optimal planting density improves rapeseed seed yield by enhancing biomass accumulation and canopy structure.

## Contribution

The study identifies specific planting density levels that optimize seed yield through improved biomass and canopy structure in rapeseed.

## Key findings

- D2 and D3 planting densities resulted in the highest seed yields due to improved biomass and light interception.
- D3 showed the highest biomass partitioning to seeds.
- D2 and D3 achieved a pod area index of 5.3–5.8, intercepting 93% of light with an even canopy distribution.

## Abstract

Planting density is an important factor affecting plant growth and yield formation in rapeseed. However, the understanding of the mechanism underlying the impact of planting density on biomass, canopy, and ultimate seed yield remains limited. A field experiment was conducted to investigate the effect of planting density on seed yield, yield components, biomass accumulation and partitioning, and canopy structure. Five planting density levels were set as D1 (2.4 × 105 plants ha−1), D2 (3.6 × 105 plants ha−1), D3 (5.4 × 105 plants ha−1), D4 (6.0 × 105 plants ha−1), and D5 (7.2 × 105 plants ha−1). The results showed that with planting density increasing from D1 to D3, the seed yield, number of pods in population, and 1000-seed weight increased, while seedling survival rate, yield per plant, number of pods per plant, and number of seeds per plant decreased. When planting density increased to D4 and D5, seed yield dramatically decreased due to a decreased number of seeds per pod and 1000-seed weight. Increasing planting density from D1 to D3 increased biomass accumulation in all organs. D3 produced the highest biomass partitioning in seeds. In addition, D2 and D3 treatments had a high level of pod area index (5.3–5.8), which caused an approximately 93% of the light to be intercepted. The distribution of light in D2 and D3 was more evenly spread, with the upper and lower parts of the canopy displaying a distribution ratio of roughly 7:3. Therefore, D2 and D3 produced the highest seed yields. In conclusion, D2 and D3 are recommended in rapeseed production due to their role in improving biomass accumulation and partitioning and canopy structure.