Data-driven control of hydraulic impact hammers under strict operational and control constraints

TL;DR

This paper introduces a data-driven control approach for hydraulic impact hammers, enabling precise positioning under operational constraints using supervised learning, reinforcement learning, and model predictive control, validated on a mini-excavator arm.

Contribution

It presents a novel methodology combining supervised learning, RL, and MPC for system identification and control of hydraulic impact hammers with limited sensing and discrete control interfaces.

Findings

RL policy achieves sub-12cm position error in real-world tests

System identification uses only 68 minutes of teleoperation data

No adjustments needed for successful Sim2Real transfer

Abstract

This paper presents a data-driven methodology for the control of static hydraulic impact hammers, also known as rock breakers, which are commonly used in the mining industry. The task addressed in this work is that of controlling the rock-breaker so its end-effector reaches arbitrary target poses, which is required in normal operation to place the hammer on top of rocks that need to be fractured. The proposed approach considers several constraints, such as unobserved state variables due to limited sensing and the strict requirement of using a discrete control interface at the joint level. First, the proposed methodology addresses the problem of system identification to obtain an approximate dynamic model of the hydraulic arm. This is done via supervised learning, using only teleoperation data. The learned dynamic model is then exploited to obtain a controller capable of reaching target end-effector poses. For policy synthesis, both reinforcement learning (RL) and model predictive control (MPC) algorithms are utilized and contrasted. As a case study, we consider the automation of a Bobcat E10 mini-excavator arm with a hydraulic impact hammer attached as end-effector. Using this machine, both the system identification and policy synthesis stages are studied in simulation and in the real world. The best RL-based policy consistently reaches target end-effector poses with position errors below 12 cm and pitch angle errors below 0.08 rad in the real world. Considering that the impact hammer has a 4 cm diameter chisel, this level of precision is sufficient for breaking rocks. Notably, this is accomplished by relying only on approximately 68 min of teleoperation data to train and 8 min to evaluate the dynamic model, and without performing any adjustments for a successful policy Sim2Real transfer. A demonstration of policy execution in the real world can be found in https://youtu.be/e-7tDhZ4ZgA.