Learning to Quantize and Precode in Massive MIMO Systems for Energy Reduction: a Graph Neural Network Approach

TL;DR

This paper introduces a graph neural network-based method for non-linear precoding in massive MIMO systems with coarse quantization, significantly reducing power consumption while maintaining high data rates.

Contribution

It proposes a self-supervised GNN approach with Gumbel-softmax gradient estimation for energy-efficient precoding in massive MIMO systems with low-resolution DACs.

Findings

Achieves similar sum rate as MRT with 1-bit DACs

Reduces DAC power consumption by a factor of 4-7

Maintains power reduction up to 3.5 MHz bandwidth

Abstract

Massive MIMO systems are moving toward increased numbers of radio frequency chains, higher carrier frequencies and larger bandwidths. As such, digital-to-analog converters (DACs) are becoming a bottleneck in terms of hardware complexity and power consumption. In this work, non-linear precoding for coarsely quantized downlink massive MIMO is studied. Given the NP-hard nature of this problem, a graph neural network (GNN) is proposed that directly outputs the precoded quantized vector based on the channel matrix and the intended transmit symbols. The model is trained in a self-supervised manner, by directly maximizing the achievable rate. To overcome the non-differentiability of the objective function, introduced due to the non-differentiable DAC functions, a straight-through Gumbel-softmax estimation of the gradient is proposed. The proposed method achieves a significant increase in achievable sum rate under coarse quantization. For instance, in the single-user case, the proposed method can achieve the same sum rate as maximum ratio transmission (MRT) by using one-bit DAC's as compared to 3 bits for MRT. This reduces the DAC's power consumption by a factor 4-7 and 3 for baseband and RF DACs respectively. This, however, comes at the cost of increased digital signal processing power consumption. When accounting for this, the reduction in overall power consumption holds for a system bandwidth up to 3.5 MHz for baseband DACs, while the RF DACs can maintain a power reduction of 2.9 for higher bandwidths. Notably, indirect effects, which further reduce the power consumption, such as a reduced fronthaul consumption and reduction in other components, are not considered in this analysis.