A Deep Learning Based Method for Fast Registration of Cardiac Magnetic Resonance Images

TL;DR

This paper introduces a fast, efficient deep learning model for cardiac MRI image registration that achieves high accuracy and consistency in tissue strain measurement, suitable for clinical use.

Contribution

A novel lightweight deep learning model (FLIR) for rapid volumetric cardiac image registration, enabling accurate tissue motion analysis with reduced inference time.

Findings

Achieves registration accuracy comparable to state-of-the-art models.

Runs significantly faster on common hardware.

Provides consistent strain measurements across similar acquisitions.

Abstract

Image registration is used in many medical image analysis applications, such as tracking the motion of tissue in cardiac images, where cardiac kinematics can be an indicator of tissue health. Registration is a challenging problem for deep learning algorithms because ground truth transformations are not feasible to create, and because there are potentially multiple transformations that can produce images that appear correlated with the goal. Unsupervised methods have been proposed to learn to predict effective transformations, but these methods take significantly longer to predict than established baseline methods. For a deep learning method to see adoption in wider research and clinical settings, it should be designed to run in a reasonable time on common, mid-level hardware. Fast methods have been proposed for the task of image registration but often use patch-based methods which can affect registration accuracy for a highly dynamic organ such as the heart. In this thesis, a fast, volumetric registration model is proposed for the use of quantifying cardiac strain. The proposed Deep Learning Neural Network (DLNN) is designed to utilize an architecture that can compute convolutions incredibly efficiently, allowing the model to achieve registration fidelity similar to other state-of-the-art models while taking a fraction of the time to perform inference. The proposed fast and lightweight registration (FLIR) model is used to predict tissue motion which is then used to quantify the non-uniform strain experienced by the tissue. For acquisitions taken from the same patient at approximately the same time, it would be expected that strain values measured between the acquisitions would have very small differences. Using this metric, strain values computed using the FLIR method are shown to be very consistent.