AC-Augmented Dielectric Barrier Discharge

TL;DR

This paper demonstrates that using an AC-augmented electrical field in a three-electrode dielectric barrier discharge setup significantly enhances EHD force and thrust, enabling improved flow control at higher Reynolds numbers.

Contribution

It introduces an AC-augmented electrode configuration that increases EHD force by up to 40%, providing a new method to improve DBD plasma actuator performance.

Findings

EHD force increased by up to 40% with AC augmentation.

Maximum thrust achieved was 54 mN/m under optimal phase conditions.

AC augmentation mechanism involves additional charge pull action from the third electrode.

Abstract

Dielectric barrier discharge (DBD) plasma actuators generate an electrohydrodynamic (EHD) force through the ionization and acceleration of charged species. Most active flow control DBD applications are only practical at lower Reynolds numbers, and increasing the momentum injection can extend the practical uses of the technology. Here, we experimentally demonstrate improvement in the performance of a planar DBD actuator by utilizing an AC-augmented electrical field in a three-electrode geometry. Time-resolved electrical and optical measurements, velocity profiles, and direct thrust measurements were used to characterize the EHD augmentation. Varying phase shift and E-field strength between the two air-exposed DBD electrodes can accelerate EHD flow and increase EHD forcing by up to ~ 40%. At the most favorable conditions, the maximum thrust was 54 mN/m when the air-exposed electrodes were out of phase. In-phase operation of the exposed electrodes at high E-field conditions can induce adverse effects and sliding discharge. Mechanistically, the performance improvements in the AC-augmented DBD actuator primarily come from the additional charge pull action by the third electrode. The insight into the AC-augmented DBD mechanism allows for developing multi-stage arrays capable of further increasing EHD forces.