In-situ Controller Autotuning by Bayesian Optimization for Closed-loop Feedback Control of Laser Powder Bed Fusion Process

TL;DR

This paper introduces Bayesian Optimization for automatic in-layer controller tuning in laser powder bed fusion, improving process stability and reducing overheating by optimizing controller parameters during manufacturing.

Contribution

It presents novel online and offline Bayesian Optimization methods for in-layer controller tuning in LPBF, demonstrating their effectiveness in experimental setups.

Findings

BO effectively tunes controllers, reducing overheating.

Partial porosity issues linked to laser power control.

First microstructural analysis of printed parts with in-layer control.

Abstract

Open-loop control of laser powder bed fusion (LPBF) additive manufacturing (AM) has enabled the production of complex, high-criticality parts for various industries. This method relies on static parameter sets from extensive experimentation and simulations, hoping they remain stable and defect-free in production. Closed-loop control of LPBF can further enhance process stability and reduce defects despite complex thermal histories, process noise, hardware drift, and unexpected perturbations. Controller performance depends on parameter tuning, traditionally a manual, expertise-driven process with no guarantee of optimal performance and limited transferability between systems. This study proposes Bayesian Optimization (BO) to automate in-layer controller tuning by leveraging LPBF's layer-to-layer repetitive nature. Two approaches are introduced: online tuning, adjusting parameters iteratively during the process, and offline tuning, conducted in a setup such as laser exposures on a bare metal plate. These methods are experimentally implemented on an in-layer PI controller, and the performance is investigated on two wedge geometries prone to overheating. Results show that BO effectively tunes controllers using either method, significantly reducing overheating in controlled wedge specimens compared to uncontrolled ones. This study presents the first printed parts controlled by an in-layer controller subjected to microstructural analysis. Findings reveal partial presence of lack-of-fusion porosities due to insufficient laser power assigned by the controller, highlighting a significant challenge for utilizing laser power controllers. In summary, BO presents a promising method for automatic in-layer controller tuning in LPBF, enhancing control precision and mitigating overheating in production parts.