Additive engineering for Sb$_2$S$_3$ indoor photovoltaics with efficiency exceeding 17%

TL;DR

This study demonstrates that additive engineering with monoethanolamine significantly improves Sb$_2$S$_3$ solar cell quality, achieving over 17% efficiency for indoor photovoltaics, suitable for powering IoT devices.

Contribution

It introduces a novel additive engineering method using monoethanolamine to enhance Sb$_2$S$_3$ film quality and indoor photovoltaic efficiency beyond previous records.

Findings

Achieved 17.55% efficiency under indoor lighting conditions.

Controlled film nucleation and growth with additive engineering.

Enabled large-area modules for IoT sensor power.

Abstract

Indoor photovoltaics (IPVs) have attracted increasing attention for sustainably powering Internet of Things (IoT) electronics. Sb$_2$S$_3$ is a promising IPV candidate material with a bandgap of ~1.75 eV, which is near the optimal value for indoor energy harvesting. However, the performance of Sb$_2$S$_3$ solar cells is limited by nonradiative recombination, closely associated with the poor-quality absorber films. Additive engineering is an effective strategy to improved the properties of solution-processed films. This work shows that the addition of monoethanolamine (MEA) into the precursor solution allows the nucleation and growth of Sb$_2$S$_3$ films to be controlled, enabling the deposition of high-quality Sb$_2$S$_3$ absorbers with reduced grain boundary density, optimized band positions and increased carrier concentration. Complemented with computations, it is revealed that the incorporation of MEA leads to a more efficient and energetically favorable deposition for enhanced heterogeneous nucleation on the substrate, which increases the grain size and accelerates the deposition rate of Sb$_2$S$_3$ films. Due to suppressed carrier recombination and improved charge-carrier transport in Sb$_2$S$_3$ absorber films, the MEA-modulated Sb$_2$S$_3$ solar cell yields a power conversion efficiency (PCE) of 7.22% under AM1.5G illumination, and an IPV PCE of 17.55% under 1000 lux white light emitting diode (WLED) illumination, which is the highest yet reported for Sb$_2$S$_3$ IPVs. Furthermore, we construct high performance large-area Sb$_2$S$_3$ IPV modules to power IoT wireless sensors, and realize the long-term continuous recording of environmental parameters under WLED illumination in an office. This work highlights the great prospect of Sb$_2$S$_3$ photovoltaics for indoor energy harvesting.