Estimated electric conductivities of thermal plasma for air-fuel combustion and oxy-fuel combustion with potassium or cesium seeding

TL;DR

This paper presents a comprehensive model to estimate the electric conductivity of seeded combustion gases, crucial for magnetohydrodynamic power generation, considering various fuels, oxidizers, and seed materials across a temperature range.

Contribution

The paper introduces a detailed thermal ionization model for predicting electric conductivity in seeded combustion gases, incorporating electron scattering mechanisms and validated against experimental data.

Findings

Electric conductivity varies significantly with temperature, fuel, oxidizer, and seed type.

Potassium seeding yields lower conductivity than cesium at the same conditions.

Replacing potassium with cesium increases conductivity by a factor of about 3.6 at 2000 K.

Abstract

A complete model for estimating the electric conductivity of combustion product gases, with added cesium (Cs) or potassium (K) vapor for ionization, is presented. Neutral carrier gases serve as the bulk fluid that carries the seed material, as well as the electrons generated by the partial thermal (equilibrium) ionization of the seed alkali metal. The model accounts for electron-neutral scattering, as well as electron-ion and electron-electron scattering. The model is tested through comparison with published data. The model is aimed at being utilized for the plasma within magnetohydrodynamic (MHD) channels, where direct power extraction from passing electrically conducting plasma gas enables electric power generation. The thermal ionization model is then used to estimate the electric conductivity of seeded combustion gases under complete combustion of three selected fuels, namely: hydrogen (H2), methane (CH4), and carbon (C). For each of these three fuels, two options for the oxidizer were applied, namely: air (21 % molecular oxygen, 79 % molecular nitrogen by mole), and pure oxygen (oxy-combustion). Two types of seeds (with 1 % mole fraction, based on the composition before ionization) were also applied for each of the six combinations of (fuel-oxidizer), leading to a total of 12 different MHD plasma cases. For each of these cases, the electric conductivity was computed for a range of temperatures from 2000 K to 3000 K. The smallest estimated electric conductivity was 0.35 S/m for oxy-hydrogen combustion at 2000 K, with potassium seeding. The largest estimated electric conductivity was 180.30 S/m for oxy-carbon combustion at 3000 K, with cesium seeding. At 2000 K, replacing potassium with cesium causes a gain in the electric conductivity by a multiplicative gain factor of about 3.6 regardless of the fuel and oxidizer. This gain factor declines to between 1.77 and 2.07 at 3000 K.