An affordable and customizable wave buoy for the study of wave-ice interactions: design concept and results from field deployments

TL;DR

This paper introduces a low-cost, customizable wave buoy using 3D printing technology, capable of long-term deployment in polar regions, with performance comparable to expensive instruments, enhancing wave-ice interaction studies.

Contribution

It presents a novel, affordable wave buoy design utilizing 3D printing for rapid customization and improved survivability, suitable for long-term polar deployments.

Findings

Performance comparable to expensive instruments in wave spectrum measurement

Successful deployment in Pacific and Arctic Oceans

Enhanced customizability and survivability of the buoy design

Abstract

In the polar regions, the interaction between waves and ice has a crucial impact on the seasonal change in the sea ice extent. However, our comprehension of this phenomenon is restricted by a lack of observations, which, in turn, results in the exclusion of associated processes from numerical models. In recent years, availability of the low-cost and accurate Inertial Motion Units has enabled the development of affordable wave research devices. Despite advancements in designing innovative open-source instruments optimized for deployment on ice floes, their customizability and survivability remain limited, especially in open waters. This study presents a novel design concept for an affordable and customizable wave buoy, aimed for wave measurements in marginal ice zones. The central focus of this wave buoy design is the application of 3D printing as rapid prototyping technology. By utilizing the high customizability offered by 3D printing, the previously developed solar-powered wave buoy was customized to install a battery pack to continue the measurements in the high latitudes for more than several months. Preliminary results from field deployments in the Pacific and Arctic Oceans demonstrate that the performance of the instruments is promising. The accuracy of frequency wave spectra measurements is found to be comparable to that of considerably more expensive instruments. Finally, the study concludes with a general evaluation of using rapid prototyping technologies for buoy designs and proposes recommendations for future designs.