D-Egg: a Dual PMT Optical Module for IceCube

TL;DR

The D-Egg optical module for IceCube enhances photon detection efficiency with dual high-quantum efficiency PMTs in an elongated sphere, enabling improved sensitivity and event recording for future ice-based neutrino detection.

Contribution

This paper introduces the D-Egg design, a new dual-PMT optical module with increased sensitivity and optimized shape for IceCube upgrades, including mass production and performance evaluation.

Findings

Effective photodetection sensitivity is 2.8 times larger than IceCube DOMs.

Mass production of 277 D-Eggs completed for IceCube Upgrade.

Laboratory tests confirm high sensitivity and multi-photon detection capabilities.

Abstract

The D-Egg, an acronym for ``Dual optical sensors in an Ellipsoid Glass for Gen2,'' is one of the optical modules designed for future extensions of the IceCube experiment at the South Pole. The D-Egg has an elongated-sphere shape to maximize the photon-sensitive effective area while maintaining a narrow diameter to reduce the cost and the time needed for drilling of the deployment holes in the glacial ice for the optical modules at depths up to 2700 meters. The D-Egg design is utilized for the IceCube Upgrade, the next stage of the IceCube project also known as IceCube-Gen2 Phase 1, where nearly half of the optical sensors to be deployed are D-Eggs. With two 8-inch high-quantum efficiency photomultiplier tubes (PMTs) per module, D-Eggs offer an increased effective area while retaining the successful design of the IceCube digital optical module (DOM). The convolution of the wavelength-dependent effective area and the Cherenkov emission spectrum provides an effective photodetection sensitivity that is 2.8 times larger than that of IceCube DOMs. The signal of each of the two PMTs is digitized using ultra-low-power 14-bit analog-to-digital converters with a sampling frequency of 240 MSPS, enabling a flexible event triggering, as well as seamless and lossless event recording of single-photon signals to multi-photons exceeding 200 photoelectrons within 10 nanoseconds. Mass production of D-Eggs has been completed, with 277 out of the 310 D-Eggs produced to be used in the IceCube Upgrade. In this paper, we report the des\ ign of the D-Eggs, as well as the sensitivity and the single to multi-photon detection performance of mass-produced D-Eggs measured in a laboratory using the built-in data acquisition system in each D-Egg optical sensor module.