Development of novel single-die hybridisation processes for small-pitch pixel detectors

TL;DR

This paper presents two innovative hybridisation techniques for small-pitch pixel detectors, demonstrating high-yield interconnects suitable for vertex-detector applications at future colliders.

Contribution

It introduces a novel industrial fine-pitch solder bump-bonding process and an in-house ACF-based interconnection method for single-die pixel detectors.

Findings

Achieved 99.7% interconnect yield with bump-bonded ASICs and sensors.

Successfully qualified ACF hybridisation with Timepix3 ASICs and 55um pitch sensors.

Demonstrated potential for replacing traditional wire bonding in pixel detector assembly.

Abstract

Hybrid pixel detectors require a reliable and cost-effective interconnect technology adapted to the pitch and die sizes of the respective applications. During the ASIC and sensor R\&D phase, especially for small-scale applications, such interconnect technologies need to be suitable for the assembly of single dies, typically available from Multi-Project-Wafer submissions. Within the CERN EP R&D programme and the AIDAinnova collaboration, innovative hybridisation concepts targeting vertex-detector applications at future colliders are under development. Recent results of two novel interconnect methods for pixel pitches of 25um and 55um are presented in this contribution -- an industrial fine-pitch SnAg solder bump-bonding process adapted to single-die processing using support wafers, as well as a newly developed in-house single-die interconnection process based on ACF. The fine-pitch bump-bonding process is qualified with hybrid assemblies from a recent bonding campaign at Frauenhofer IZM. Individual CLICpix2 ASICs with 25um pixel pitch were bump-bonded to active-edge silicon sensors with thicknesses ranging from 50um to 130um. The device characterisation was conducted in the laboratory as well as during a beam test campaign at the CERN SPS beam-line, demonstrating an interconnect yield of about 99.7%. The ACF interconnect technology replaces the solder bumps by conductive micro-particles embedded in an epoxy film. The electro-mechanical connection between the sensor and ASIC is achieved via thermocompression of the ACF using a flip-chip device bonder. The required pixel pad topology is achieved with an in-house ENIG plating process. This newly developed ACF hybridisation process is first qualified with the Timepix3 ASICs and sensors with 55um pixel pitch. The technology can be also used for ASIC-PCB/FPC integration, replacing wire bonding or large-pitch solder bumping techniques.