The defocused observations of bright sources with Athena/X-IFU

TL;DR

This paper presents a novel method for reconstructing high-resolution X-ray spectra from bright sources observed with Athena's X-IFU in defocused mode, addressing energy-dependent artefacts caused by high photon rates.

Contribution

It introduces a new energy-dependent ARF reconstruction technique for defocused X-IFU observations, enabling unbiased spectral analysis of extremely bright X-ray sources.

Findings

Successful spectral reconstruction without bias in simulated data.

Effective handling of energy-dependent artefacts in high flux observations.

Enhanced capability to observe sources up to 1 Crab flux.

Abstract

The X-ray Integral Field Unit (X-IFU) is the high resolution X-ray spectrometer of ESA's Athena X-ray observatory. It will deliver X-ray data in the 0.2-12 keV band with an unprecedented spectral resolution of 2.5 eV up to 7 keV. During the observation of very bright X-ray sources, the X-IFU detectors will receive high photon rates. The count rate capability of the X-IFU will be improved by using the defocusing option, which will enable the observations of extremely bright sources with fluxes up to $\simeq 1$ Crab. In the defocused mode, the point spread function (PSF) of the telescope will be spread over a large number of pixels. In this case, each pixel receives a small fraction of the overall flux. Due to the energy dependence of the PSF, this mode will generate energy dependent artefacts increasing with count rate if not analysed properly. To account for the degradation of the energy resolution with pulse separation in a pixel, a grading scheme (here four grades) will be defined to affect the proper energy response to each event. This will create selection effects preventing the use of the nominal Auxiliary Response File (ARF) for all events. We present a new method for the reconstruction of the spectra obtained from observations performed with a PSF that varies as a function of energy. We apply our method to the case of the X-IFU spectra obtained during the defocused observations. We use the end-to-end SIXTE simulator to model defocused X-IFU observations. Then we estimate new ARF for each of the grades by calculating the effective area at the level of each pixel. Our method allows us to successfully reconstruct the spectra of bright sources when employed in the defocused mode, without any bias. Finally, we address how various sources of uncertainty related to our knowledge of the PSF as a function of energy affect our results.