Direct 3D Printing of Soft Fluidic Actuators with Graded Porosity

TL;DR

This paper introduces InFoam, a novel additive manufacturing technique using liquid rope coiling to create soft fluidic actuators with graded porosity, enabling customizable mechanical behavior and complex deformation patterns.

Contribution

The InFoam method is the first to print graded porosity structures in soft robotics using liquid rope coiling, allowing for programmable deformation and mechanical properties.

Findings

Porosity ranged from 46% to 89% in printed structures.

Large changes in modulus and energy dissipation were observed.

Porosity grading enabled complex deformation patterns.

Abstract

New additive manufacturing methods are needed to realize more complex soft robots. One example is soft fluidic robotics, which exploits fluidic power and stiffness gradients. Porous structures are an interesting type for this approach, as they are flexible and allow for fluid transport. Within this work, the Infill-Foam (InFoam) is proposed to print structures with graded porosity by liquid rope coiling (LRC). By exploiting LRC, the InFoam method could exploit the repeatable coiling patterns to print structures. To this end, only the characterization of the relation between nozzle height and coil radius and the extruded length were necessary (at a fixed temperature). Then by adjusting the nozzle height and/or extrusion speed the porosity of the printed structure could be set. The InFoam method was demonstrated by printing porous structures using styrene-ethylene-butylene-styrene (SEBS) with porosities ranging from 46\% to 89\%. In compression tests, the cubes showed large changes in modulus (more than 200 times), density (-89\% compared to bulk), and energy dissipation. The InFoam method combined coiling and normal plotting to realize a large range of porosity gradients. This grading was exploited to realize rectangular structures with varying deformation patterns, which included twisting, contraction, and bending. Furthermore, the InFoam method was shown to be capable of programming the behavior of bending actuators by varying the porosity. Both the output force and stroke showed correlations similar to those of the cubes. Thus, the InFoam method can fabricate and program the mechanical behavior of a soft fluidic (porous) actuator by grading porosity.