Comparing Different Approaches for Stellar Intensity Interferometry

TL;DR

This paper compares two approaches to stellar intensity interferometry, analyzing their effectiveness in measuring stellar signals with different optical setups and discussing their optimal operational regimes.

Contribution

The study provides a direct experimental comparison of high time-resolution and high photon rate interferometry setups for stellar intensity measurements.

Findings

Both setups successfully measure expected correlation signals.

Measurements operate at the shot-noise limit for measurement times from 10 minutes to 23 hours.

Quantitative differences in performance depend on the specific operational regime.

Abstract

Stellar intensity interferometers correlate photons within their coherence time and could overcome the baseline limitations of existing amplitude interferometers. Intensity interferometers do not rely on phase coherence of the optical elements and thus function without high grade optics and light combining delay lines. However, the coherence time of starlight observed with realistic optical filter bandwidths (> 0.1 nm) is usually much smaller than the time resolution of the detection system (> 10 ps), resulting in a greatly reduced correlation signal. Reaching high signal to noise in a reasonably short measurement time can be achieved in different ways: either by increasing the time resolution, which increases the correlation signal height, or by increasing the photon rate, which decreases statistical uncertainties of the measurement. We present laboratory measurements employing both approaches and directly compare them in terms of signal to noise ratio. A high time-resolution interferometry setup designed for small to intermediate size optical telescopes and thus lower photon rates (diameters < some meters) is compared to a setup capable of measuring high photon rates, which is planned to be installed at Cherenkov telescopes with dish diameters of > 10 m. We use a Xenon lamp as a common light source simulating starlight. Both setups measure the expected correlation signal and work at the expected shot-noise limit of statistical uncertainties for measurement times between 10 min and 23 h. We discuss the quantitative differences in the measurement results and give an overview of suitable operation regimes for each of the interferometer concepts.