Analysis of a Casimir-driven Parametric Amplifier with Resilience to Casimir Pull-in for MEMS Single-Point Magnetic Gradiometry

TL;DR

This paper presents a novel Casimir-driven parametric amplifier design for MEMS-based magnetic gradiometry, achieving high sensitivity and resilience to pull-in, enabling potential unshielded biomagnetic field monitoring.

Contribution

The work introduces a time-delay based parametric amplification technique that prevents Casimir pull-in and enhances MEMS sensor sensitivity for low-frequency biomagnetic detection.

Findings

Achieved 10,000-fold improvement in resolution.

Maximum sensitivity of 6 Hz/(pT/cm) at 1 Hz.

Demonstrated potential for unshielded biomagnetic field monitoring.

Abstract

The Casimir Force, a quantum mechanical effect, has been observed in several microelectromechanical systems (MEMS) platforms. Due to its extreme sensitivity to the separation of two objects, the Casimir Force has been proposed as an excellent avenue for quantum metrology. Practical application, however, is challenging due to attractive forces leading to stiction and failure of the device, called Casimir pull-in. In this work, we design and simulate a Casimir-driven metrology platform, where a time-delay based parametric amplification technique is developed to achieve a steady state and avoid pull-in. We apply the design to the detection of weak, low frequency, gradient magnetic fields, similar to those emanating from ionic currents in the heart and brain. Simulation parameters are selected from recent experimental platforms developed for Casimir metrology and magnetic gradiometry, both on MEMS platforms. While MEMS offer many advantages to such an application, the detected signal must typically be at the resonant frequency of the device, with diminished sensitivity in the low frequency regime of biomagnetic fields. Using a Casimir-drive parametric amplifier, we report a 10,000 fold improvement in the best-case resolution of MEMS single-point gradiometers, with a maximum sensitivity of 6 Hz/(pT/cm) at 1 Hz. The development of the proposed design has the potential to revolutionize metrology, and specifically may enable unshielded monitoring of biomagnetic fields in ambient conditions.