Fluidic Shaping of Freeform Optical Components

TL;DR

This paper introduces a rapid prototyping method for freeform optical components by shaping and solidifying liquids, enabling high-quality, customizable optical surfaces in minutes.

Contribution

It presents an analytical approach to design freeform surfaces via controlling liquid interface energy states, facilitating fast and precise manufacturing.

Findings

Successful fabrication of a 35 mm freeform optical component

Achieved sub-nanometer surface roughness within minutes

Demonstrated deterministic design of complex freeform topographies

Abstract

Freeform optical components offer significant compactization of multi-lens systems, as well as advanced manipulation of light that is not possible with traditional systems. However, their fabrication relies on machining processes that are complex, time-consuming, and incompatible with rapid prototyping. This work presents the ability to shape liquid volumes and solidify them into desired freeform components, enabling rapid freeform prototyping with high surface quality. The method is based on controlling the minimum energy state of the interface between a curable optical liquid and an immersion liquid, by dictating a geometrical boundary constraint. The boundary shape is modeled as a cylinder whose arbitrary height is expressed as a Fourier series, allowing for an analytical solution of the resulting freeform surface as a sum of Fourier-Bessel functions. Each of these functions represents a different basic mode, whose superposition creates complex topographies. This solution allows deterministic design of freeform surfaces by controlling three key parameters - the volume of the optical liquid, the density of the immersion liquid, and the shape of the bounding frame. The paper describes a complete workflow for rapid prototyping of such components, and demonstrates the fabrication of a 35 mm diameter freeform component with sub-nanometer surface roughness within minutes.