Salt-Driven Assembly of Magnetic Silica Microbeads with Tunable Porosity

TL;DR

This paper presents a simple, eco-friendly method to produce magnetic silica microbeads with tunable porosity and size, using salt-induced agglomeration in emulsions, suitable for biological and environmental applications.

Contribution

It introduces a novel, cost-effective approach for fabricating magnetic silica beads with controllable properties via colloidal destabilization in water-in-oil emulsions.

Findings

Beads with diameters of 1-9 micrometers produced.

Magnetic response confirmed with up to 84% yield.

Porosity and roughness tuned by surfactant addition.

Abstract

Porous magnetic silica beads are promising materials for biological and environmental applications due to their enhanced adsorption and ease of recovery. This work aims to develop a new, inexpensive and environmentally friendly approach based on agglomeration of nanoparticles in aqueous droplets. The use of an emulsion as a geometrical constraint is expected to result in the formation of spherical beads with tunable composition depending on the aqueous phase content. Magnetic silica beads are produced at room temperature by colloidal destabilization induced by addition of calcium chloride to a water-in-oil emulsion containing silica and iron oxide nanoparticles. The impact of the salt concentration, emulsification method, concentration of hydrophobic surfactant as well as silica content is presented in this paper. This method enables the production of spherical beads with diameters between 1 and 9 micrometers. The incorporation of magnetic nanoparticles inside the beads structure is confirmed using Energy Dispersive X-ray spectrometry and Scanning Transmission Electron Microscopy and results in the production of magnetic responsive beads with a preparation yield up to 84 percent. By incorporating the surfactant Span 80 in the oil phase it is possible to tune the roughness and porosity of the beads.