Enhanced Figure of Merit in Bismuth-Antimony Fine-Grained Alloys at Cryogenic Temperatures

TL;DR

This study demonstrates a significant enhancement in the thermoelectric figure of merit (ZT) of bismuth-antimony alloys at cryogenic temperatures, achieved through microstructural control and magnetic effects, promising improved cooling applications.

Contribution

The paper reports the first observation of a record high ZT of 0.6 in melt-spun Bi-Sb alloys at cryogenic temperatures, with insights into microstructure and magneto-thermoelectric effects.

Findings

Achieved ZT of 0.6 near 100-150K in Bi-Sb alloys.

Record low thermal conductivity of ~1.5 W/m·K at 100K.

Magneto-thermoelectric effects further increased ZT to about 0.7.

Abstract

Thermoelectric (TE) materials research plays a vital role in heat-to-electrical energy conversion and refrigeration applications. Bismuth-antimony (Bi-Sb) alloy is a promising material for thermoelectric cooling. Herein, a high figure of merit, ZT, near 0.6 at cryogenic temperatures (100-150K) has been achieved in melt-spun n-type Bi85Sb15 bulk samples consisting of micron-size grains. The achieved ZT is nearly 50 percents higher than polycrystalline averaged single crystal ZT of ~0.4, and it is also significantly higher than ZT of less than ~0.3 measured below 150K in Bi-Te alloys commonly used for cryogenic cooling applications. The improved thermoelectric properties can be attributed to the fine-grained microstructure achieved from rapid solidification, which not only significantly reduced the thermal conductivity but also mitigated a segregation effect. A record low thermal conductivity of ~1.5 W m-1 K-1 near 100 K was measured using the hot disk method. The thermoelectric properties for this intriguing semimetal-semiconductor alloy system were analyzed within a two-band effective mass model. The study revealed a gradual narrowing of the band gap at increasing temperature in Bi-Sb alloy for the first time. Magneto-thermoelectric effects of this Bi-Sb alloy further improved the TE properties, leading to ZT of about 0.7. The magneto-TE effect was further demonstrated in a combined NdFeB/BiSb/NdFeB system. The compactness of the BiSb-magnet system with high ZT enables the utilization of magneto-TE effect in thermoelectric cooling applications.