Working principle and demonstrator of microwave-multiplexing for the HOLMES experiment microcalorimeters

TL;DR

This paper presents a microwave-multiplexing technique for reading out large arrays of microcalorimeters in the HOLMES neutrino mass experiment, enabling scalable, efficient, and low-cost sensor readout.

Contribution

It introduces a novel microwave-multiplexing approach using superconducting resonators and RF SQUIDs, demonstrating its design, implementation, and scalability for HOLMES.

Findings

Successful development of a two-channel readout prototype

Performance validation with HOLMES-specific TES detectors

Scalability to 1024 pixels explained

Abstract

The determination of the neutrino mass is an open issue in modern particle physics and astrophysics. The direct mass measurement is the only theory-unrelated experimental tool capable to probe such quantity. The HOLMES experiment aims to measure the end-point energy of the electron capture (EC) decay of $^{163}$Ho with a statistical sensitivity on the neutrino mass as low as $\sim 1$ eV/c$^2$. In order to acquire the large needed statistics, by keeping the pile-up contribution as low as possible, 1024 transition edge sensors (TESs) with high energy and time resolutions will be employed. Microcalorimeter and bolometer arrays based on transition edge sensor with thousands of pixels are under development for several space-based and ground-based applications, including astrophysics, nuclear and particle physics, and materials science. The common necessary challenge is to develop pratical multiplexing techniques in order to simplify the cryogenics and readout systems. Despite the various multiplexing variants which are being developed have been successful, new approaches are needed to enable scaling to larger pixel counts and faster sensors, as requested for HOLMES, reducing also the cost and complexity of readout. A very novel technique that meets all of these requirements is based on superconducting microwave resonators coupled to radio-frequency Superconducting Quantum Interference Devices, in which the the changes in the TES input current is tranduced to a change in phase of a microwave signal. In this work we introduce the basics of this technique, the design and development of the first two-channel read out system and its performances with the first TES detectors specifically designed for HOLMES. In the last part we explain how to extend this approach scaling to 1024 pixels.