Performance-Enhanced Non-Enzymatic Glucose Sensor Based on Graphene-Heterostructure

TL;DR

This paper introduces a graphene-based heterostructure glucose sensor with enhanced sensitivity and selectivity, achieved by optimizing platinum oxide layer thickness and supported by theoretical DFT analysis, promising improvements for continuous glucose monitoring.

Contribution

The study presents a novel G/PtO/n-Si heterostructure sensor with significantly improved sensitivity through layer optimization and theoretical insights into its detection mechanism.

Findings

Sensitivity increased by 150% with thicker PtO layers.

Achieved detection of 4-10 mM glucose with high selectivity.

Theoretical DFT analysis explained charge distribution and selectivity.

Abstract

This study proposes a novel design of glucose sensor with enhanced selectivity and sensitivity by using graphene Schottky diodes, which is composed of Graphene (G)/Platinum Oxide (PtO)/n-Silicon (Si) heterostructure. The sensor was tested with different glucose concentrations and interfering solutions to investigate its sensitivity and selectivity. Different structures of the device were studied by adjusting the platinum oxide film thickness to investigate its catalytic activity. It was found that the film thickness plays a significant role in the efficiency of glucose oxidation and hence in overall device sensitivity. 0.8-2 uA output current was obtained in the case of 4-10 mM with a sensitivity of 0.2 uA/mM.cm2. Besides, results have shown that 0.8 uA and 15 uA were obtained by testing 4 mM glucose on two different PtO thicknesses, 30 nm, and 50 nm, respectively. The sensitivity of the device was enhanced by 150% (i.e., up to 30 uA/mM.cm2) by increasing the PtO layer thickness. This was attributed to both the increase of the number of active sites for glucose oxidation as well as the increase in the graphene layer thickness, which leads to enhanced charge carriers concentration and mobility. Moreover, theoretical investigations were conducted using the Density Function Theory (DFT) to understand the detection method and the origins of selectivity better. The working principle of the sensors puts it in a competitive position with other non-enzymatic glucose sensors. DFT calculations provided a qualitative explanation of the charge distribution across the graphene sheet within a system of a platinum substrate with D-glucose molecules above. The proposed G/PtO/n-Si heterostructure has proven to satisfy these factors, which opens the door for further developments of more reliable non-enzymatic glucometers for continuous glucose monitoring systems.