Deep-Reinforcement-Learning-Based Distributed Vehicle Position Controls for Coverage Expansion in mmWave V2X

TL;DR

This paper introduces a deep reinforcement learning approach for autonomous vehicles to position themselves optimally for establishing long relay links in mmWave V2X networks, improving coverage despite environmental challenges.

Contribution

It presents a novel distributed control method using deep RL for vehicles to autonomously form long relays without full environmental information.

Findings

Increased relay length and coverage in simulations.

Effective in varying traffic and device penetration conditions.

Decentralized decision-making enables scalable relay formation.

Abstract

In millimeter wave (mmWave) vehicular communications, multi-hop relay disconnection by line-of-sight (LOS) blockage is a critical problem, especially in the early diffusion phase of mmWave-available vehicles, where not all the vehicles have mmWave communication devices. This paper proposes a distributed position control method for autonomous vehicles to make long relays connecting to road side units (RSUs) by avoiding blockages to communicate with each other via LOS paths. Even though vehicles with the proposed method do not use the whole information of the environments and cooperate with each other, they can decide their action (e.g., lane change and overtaking) to form long relays using only information of its surroundings (e.g., surrounding vehicle positions). The decision-making problem is formulated as a Markov decision process so that autonomous vehicles can learn a practical movement strategy of making long relays by a reinforcement learning (RL) algorithm. This paper designs a learning algorithm based on a sophisticated deep reinforcement learning algorithm, asynchronous advantage actor-critic (A3C), which enables vehicles to learn a complex movement strategy quickly by its deepneural-network architecture and multi-agent-learning mechanism. Once the strategy is well trained, vehicles can distributedly move to positions where the long relay to the RSU is established. Simulations results confirm that the proposed method can increase the relay length and coverage even if the traffic conditions and penetration ratio of mmWave communication devices in learning and operation phases are different.