# Energy Aware Competitiveness Power Control in Relay-Assisted Interference Body Networks

## TL;DR

This paper introduces IMA, a cooperative power control algorithm for WBANs that selects optimal relays to improve SINR, reduce power consumption, and mitigate interference, thereby enhancing network performance and extending device lifetime.

## Contribution

The paper proposes a novel relay selection algorithm, IMA, that optimizes power control in WBANs to mitigate interference and improve overall network efficiency.

## Key findings

- IMA improves SINR and power efficiency.
- IMA extends WBAN lifetime.
- IMA reduces bit error probability and enhances throughput.

## Abstract

Recent advances in microelectronics have enabled the realization of Wireless Body Area Networks (WBANs). Increasing the transmission power of WBAN's nodes improves the Signal to Interference plus Noise Ratio (SINR), and hence decreases the bit error probability. However, this increase may impose interference on nodes within the same WBAN or on other nodes of nearby coexisting WBANs, as these WBANs may use similar frequencies. Due to co-channel interference, packet collisions and retransmissions are increased and consequently, the power consumption of the individual WBANs may increase correspondingly. To address this problem, we adopt the approach of two-hop cooperative communication due to its efficiency in power savings. In this paper, we propose a cooperative power control-based algorithm, namely, IMA, for interference mitigation among the individual sensors of a single WBAN. Basically, our approach selects an optimal set of relays from the nodes within each WBAN to mitigate the interference. Thus, IMA selection criterion relies on the best channel, namely, SINR and power conditions to select the set of best relays. The experimental results illustrate that IMA improves the SINR, the power efficiency and extends WBAN lifetime. In addition, the results illustrate that IMA lowers the bit error probability and improves the throughput.