Plasmons in one and two dimensions

TL;DR

This paper reviews the properties and dispersion of plasmons in low-dimensional systems, highlighting their tunability, independence from Fermi level at short wavelengths, and effects of anisotropy and dimensionality on their behavior.

Contribution

It provides a comprehensive review of plasmon behavior in 1D and 2D systems, including experimental observations and theoretical insights into their dispersion and localization.

Findings

Plasmons in 2D systems can be tuned by charge carrier concentration.

In graphene, short-wavelength plasmons are independent of Fermi level position.

Anisotropy and coupling influence plasmon dispersion and localization.

Abstract

Plasmons in low-dimensional systems respresent an important tool for coupling energy into nanostructures and the localization of energy on the scale of only a few nanometers. Contrary to ordinary surface plasmons of metallic bulk materials, their dispersion goes to zero in the long wavelength limit, thus covering a broad range of energies from terahertz to near infrared, and from mesoscopic wavelengths down to just a few nanometers. Using specific and most characteristic examples, we review first the properties of plasmons in two-dimensional (2D) metallic layers from an experimental point of view. As demonstrated, tuning of their dispersion is possible by changes of charge carrier concentration in the partially filled 2D conduction bands, but for the relativistic electron gas like in graphene only in the long wavelength limit. For short wavelengths, on the other hand, the dispersion turns out to be independent of the position of the Fermi level with respect to the Dirac point. A linear dispersion, seen under the latter conditions in graphene, can also be obtained in non-relativistic electron gases by coupling between 2D and 3D electronic systems. As a well investigated example, the acoustic surface plasmons in Shockley surface states, coupled with the bulk electronic system, are discussed. Also the introduction of anisotropy, e.g. by regular arrays of steps, seems to result in linearization (and to partial localization of the plasmons normal to the steps, depending on wavelengths). In quasi-one dimensional (1D) systems, such as arrays of gold chains on regularly stepped Si surfaces, only the dispersion is 1D, whereas shape and slope of the dispersion curves depend on the 2D distribution of charge within each terrace and on coupling between wires on different terraces.