Construction of Triple-GEM Detectors Using Commercially Manufactured Large GEM Foils

TL;DR

This paper reports on the development and initial testing of commercially manufactured large-area GEM foils, demonstrating their performance is comparable to CERN's, and describes the construction of triple-GEM detectors for physics performance evaluation.

Contribution

It introduces commercially produced large GEM foils using the single-mask technique and details the construction of triple-GEM detectors for performance testing.

Findings

GEM foils from Tech-Etch match CERN's quality in electrical and optical tests.

Construction of triple-GEM detectors using these foils is underway.

Initial tests show promising performance comparable to CERN-produced GEMs.

Abstract

Many experiments are currently using or proposing to use large area GEM foils in their detectors, which is creating a need for commercially available GEM foils. Currently CERN is the only main distributor of large GEM foils, however with the growing interest in GEM technology keeping up with the increasing demand for GEMs will be difficult. Thus the commercialization of GEMs up to 50 $\times$ 50 cm$^2$ has been established by Tech-Etch Inc. of Plymouth, MA, USA using the single-mask technique. The electrical performance and optical quality of the single-mask GEM foils have been found to be on par with those produced by CERN. The next critical step towards validating the Tech-Etch single-mask GEM foils is to test their performance under physics conditions. These measurements will allow us to quantify and compare the gain and efficiency of the detector to other triple-GEM detectors. This will be done by constructing several single-mask triple-GEM detectors, using foils manufactured by Tech-Etch, which follow the design used by the STAR Forward GEM Tracker (FGT). These detectors will investigate ways in which to further decrease the material budget and increase the efficiency of the detector by incorporating perforated Kapton spacer rings rather than G10 spacing grids to reduce the dead area of the detector. The materials and tooling needed to assemble the triple-GEM detectors have been acquired. The GEM foils have been electrically tested, and a handful have been optically scanned. We found these results to be consistent with GEM foils produced by CERN. With the success of these initial tests, construction of the triple-GEM detectors is now under way.