A Pragmatic Smoothing Method for Improving the Quality of the Results in Atomic Spectroscopy

TL;DR

This paper introduces a new weighted smoothing method for spectral data in atomic spectroscopy that reduces noise effectively without distorting signals, improving both accuracy and precision of spectral analysis results.

Contribution

A novel weighted smoothing algorithm utilizing prior signal knowledge, enhancing noise reduction and result accuracy in atomic and nuclear spectroscopies.

Findings

Significantly reduces high-frequency noise more effectively than simple smoothing.

Improves the accuracy and precision of spectral quantification.

Potentially lowers detection and quantification limits.

Abstract

A new smoothing method for the improvement on the identification and quantification of spectral functions based on the previous knowledge of the signals that are expected to be quantified, is presented. These signals are used as weighted coefficients in the smoothing algorithm. This smoothing method was conceived to be applied in atomic and nuclear spectroscopies preferably to these techniques where net counts are proportional to acquisition time, such as particle induced X-ray emission (PIXE) and other X-ray fluorescence spectroscopic methods, etc. This algorithm, when properly applied, does not distort the form nor the intensity of the signal, so it is well suited for all kind of spectroscopic techniques. This method is extremely effective at reducing high-frequency noise in the signal much more efficient than a single rectangular smooth of the same width. As all of smoothing techniques, the proposed method improves the precision of the results, but in this case we found also a systematic improvement on the accuracy of the results. We still have to evaluate the improvement on the quality of the results when this method is applied over real experimental results. We expect better characterization of the net area quantification of the peaks, and smaller Detection and Quantification Limits. We have applied this method to signals that obey Poisson statistics, but with the same ideas and criteria, it could be applied to time series. In a general case, when this algorithm is applied over experimental results, also it would be required that the sought characteristic functions, required for this weighted smoothing method, should be obtained from a system with strong stability. If the sought signals are not perfectly clean, this method should be carefully applied