A General Design Framework for MIMO Wireless Energy Transfer with Limited Feedback

TL;DR

This paper introduces a versatile framework for MIMO wireless energy transfer that uses limited feedback from energy receivers to optimize beamforming, employing convex optimization techniques for improved channel estimation.

Contribution

It proposes a general design framework for channel learning in MIMO WET using energy measurement feedback, with two novel feedback schemes and analysis of their performance.

Findings

Energy quantization outperforms energy comparison with many feedback bits.

Energy comparison is more effective with fewer feedback bits.

The framework enhances beamforming accuracy in practical limited-feedback scenarios.

Abstract

Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy transmitter (ET), the knowledge of channel state information (CSI) is essential, which, however, is difficult to be obtained in practice due to the hardware limitation of the energy receiver (ER). To overcome this difficulty, under a point-to-point MIMO WET setup, this paper proposes a general design framework for a new type of channel learning method based on the ER's energy measurement and feedback. Specifically, the ER measures and encodes the harvested energy levels over different training intervals into bits, and sends them to the ET via a feedback link of limited rate. Based on the energy-level feedback, the ET adjusts transmit beamforming in subsequent training intervals and obtains refined estimates of the MIMO channel by leveraging the technique of analytic center cutting plane method (ACCPM) in convex optimization. Under this general design framework, we further propose two specific feedback schemes termed energy quantization and energy comparison, where the feedback bits at each interval are generated at the ER by quantizing the measured energy level at the current interval and comparing it with those in the previous intervals, respectively. Numerical results are provided to compare the performance of the two feedback schemes. It is shown that energy quantization performs better when the number of feedback bits per interval is large, while energy comparison is more effective with small number of feedback bits.