Characterizing a cluster's dynamic state using a single epoch of radial velocities

TL;DR

This paper presents a maximum likelihood method to determine a star cluster's intrinsic velocity distribution from a single epoch of radial velocity data, effectively accounting for binary orbital motions even at very low velocity dispersions.

Contribution

The paper introduces a novel statistical approach that accurately characterizes a cluster's velocity distribution from limited data, considering binary star effects.

Findings

Method accurately recovers velocity dispersion of 0.5 km/s with a single epoch.

Uncertainty in parameters mainly due to statistical errors, weakly dependent on binary assumptions.

Monte Carlo simulations guide sample size requirements for desired accuracy.

Abstract

Radial velocity measurements can be used to constrain the dynamical state of a stellar cluster. However, for clusters with velocity dispersions smaller than a few km/s the observed radial velocity distribution tends to be dominated by the orbital motions of binaries rather than the stellar motions through the potential well of the cluster. Our goal is to characterize the intrinsic velocity distribution of a cluster from a single epoch of radial velocity data, even for a cluster with a velocity dispersion of a fraction of a km/s, using a maximum likelihood procedure. Assuming a period, mass ratio, and eccentricity distribution for the binaries in the observed cluster this procedure fits a dynamical model describing the velocity distribution for the single stars and center of masses of the binaries, simultaneously with the radial velocities caused by binary orbital motions, using all the information available in the observed velocity distribution. We find that the fits to the intrinsic velocity distribution depend only weakly on the binary properties assumed, so the uncertainty in the fitted parameters tends to be dominated by statistical uncertainties. Based on Monte Carlo simulations we provide an estimate of how these statistical uncertainties vary with the velocity dispersion, binary fraction, and the number of observed stars, which can be used to estimate the sample size needed to reach a specific accuracy. Finally we test the method on the well-studied open cluster NGC 188, showing that it can reproduce a velocity dispersion of only 0.5 km/s using a single epoch of the multi-epoch radial velocity data. If the binary period, mass ratio, and eccentricity distribution of the observed stars are roughly known, this procedure can be used to correct for the effect of binary orbital motions on an observed velocity distribution. [Abridged]